Cont. x
• Field Wiring Terminal Markings B-6
• Power and Control Field Wiring Terminals B-6
• Field Grounding Terminals B-7
• Field Terminal Kits B-7
• Recommended Wire Sizes B-8
• Field Grounding Terminals B-9
• Operating Ambient Temperature B-9
• External Power Semiconductor Protection Fuses B-9
Australia & New Zealand ...................................................................B-10
EMC Standards B-10
EMC.................................................................................................B-11
Emissions Limits B-11
EMC General Installation Considerations B-13
• Earthing Requirements B-13
• Increasing Motor Cable Length B-14
Certificates........................................................................................B-15
APPENDIX C PARAMETER SPECIFICATION TABLES
Parameter Tables ............................................................................... C-1
Specification Table: Tag Number Order ............................................... C-2
Parameter Table: MMI Menu Order .................................................. C-37
APPENDIX D PROGRAMMING
Programming Your Application............................................................ D-1
Programming with Block Diagrams D-1
• Modifying a Block Diagram D-1
• Saving Your Modifications D-4
• Understanding the Function Block Description D-4
• MMI Menu Maps D-5
• Function Blocks By Category D-6
• Compatibility with Earlier Versions of Firmware D-7
Function Block Descriptions ............................................................... D-11
• 5703 IN D-11
• 5703 OUT D-12
• ADVANCED D-13
•
ALARM HISTORY D-16
•
ALARMS D-17
• ANALOG INPUTS D-21
• ANALOG OUTPUTS D-23
• AUTOTUNE D-24
• AUX I/O D-26
• CALIBRATION D-27
• COMMS PORT D-30
• CONFIGURE DRIVE D-32
• CURRENT LOOP D-33
• CURRENT PROFILE D-38
• DEADBAND D-39
• DEMULTIPLEXER D-40
• DIAMETER CALC. D-41
• DIGITAL INPUTS D-49
• DIGITAL OUTPUTS D-52
• DRIVE INFO D-55
• ENCODER D-57
• FEEDBACKS D-60
• FIELD CONTROL D-61
• INERTIA COMP D-69
• LINK D-70
• INVERSE TIME D-71
• JOG/SLACK D-72
• LOGIC FUNC D-75
• MENUS D-81
• MIN SPEED D-82
• miniLINK D-83
• MULTIPLEXER D-84
• OP STATION D-85
• PID D-87
• PLL (PHASE LOCKED LOOP) D-92
• PNO CONFIG D-93
• PRESET SPEEDS D-94
• PROFILED GAIN D-97
• RAISE/LOWER D-99
To Next Page
Loading...
