Parker 590+ DRV - Page 13

Cont. xi
• RAMPS D-102
• SELECT D-108
• SEQUENCING D-109
• SETPOINT SUM D-112
• SPEED LOOP D-115
• SRAMP D-122
• STANDSTILL D-125
• STOP RATES D-128
• TEC OPTION D-131
• TORQUE CALC. D-133
• VALUE FUNC D-134
The Default Application................................................................... D-145
Block Diagrams D-145
• Programming Block Diagram - Sheet 1 D-146
• Programming Block Diagram - Sheet 2 D-147
• Programming Block Diagram - Sheet 3 D-148
• Programming Block Diagram - Sheet 4 D-149
• Main Block Diagram D-150
• Field Control Block Diagram D-151
• Start/Healthy Logic Block Diagram D-152
• Functional Block Diagram D-153
APPENDIX E TECHNICAL SPECIFICATIONS
Technical Specifications........................................................................ E-1
• Environmental Details E-1
• Electrical Ratings - Power Circuit E-2
• 3-Phase Power Supply Details E-4
• Control Power Supply Detail E-4
• AC Line Reactor (Frames 1, 2, 3, 4 & 5) E-5
• AC Line Reactor (Frames 1, 2, 3, 4 & 5) E-6
• Input Line Fuses (Frames 1, 2, 3, 4, & 5) E-7
• Earthing/Grounding Safety Details E-8
• Terminal Definitions (Digital/Analog Inputs & Outputs) E-9
•
Terminal Information - Power (Frames 1-5) E-10
•
Terminal Information - Power (Frames 6 & 7) E-14
• Terminal Information – Control Board E-16
• Terminal Information - Option Boards E-21
• Wiring Requirements for EMC Compliance E-22
• Wire Sizes and Termination Tightening Torques (Frames 1, 2, 3, 4 &
5) E-23
• Termination Tightening Torque (Frame 6) E-26
• Termination Tightening Torque (Frame 7) E-26
• Dynamic Braking E-26
• Cooling Fans E-27
• Spares List (Frames 1-5 & 7) E-28
• Spares List (Frame 6) E-34