23
6.3.4 SENSOR CONTROL
Offset Control
Select Auto to automatically compensate dark current and
signal drift of the offset. Select Off to deactivate Offset
Control.
The offset is recalculated if the exposure time is changed during
a Record session. This applies also if any setting in Camera
Properties is changed. The offset is not recalculated if only
recording is stopped and restarted.
BW Noise Filter
In addition to the processing of the embedded unchangeable defect
pixel list, a dynamic noise filter can be activated to remove so-called
blinkers and high noise pixels. If you encounter unexpected aliasing
effects, turn this filter off.
6.3.5 RECORDING CONTROL
Recorder Mode
Camware uses free RAM space on your computer. The recorded
images are temporarily saved as 16 bit multi TIFF. In Sequence
mode the recording stops when RAM space is full. In Ring
Buffer mode the camera stops only by a stop command, hence
overwriting previous images. For longer recording periods an
appropriate RAID system is necessary, see also the Direct
Record to File option (see 6.9.2).
Acquire Mode
The Acquire Mode enables or disables the recording by an external
signal. If set to Auto all images are accepted and all images taken are
saved. A signal at the Acquire Enable input SMA #2 (see chapter
6.3.7) is ignored for this function. Operation of the Acquire Mode
depends on the selected Trigger Mode (see 6.3.1).
To Next Page
Loading...
Need help?
General
