EasyManuals Logo

Pendulum CNT-91R Programmer's Handbook

Default Icon
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
8-6 Command Reference
:ARM :COUNt
8 <Numeric value>|MIN|MAX|INFinity *
No. of Measurements on each Bus arm
This count variable controls the upward exit of the “wait-for-bus-arm” state
(:ARM:STARt:LAY1). The counter loops the trigger subsystem downwards COUNt
number of times before it exits to the idle state.
This means that a COUNt No. of measurements can be done for each Bus arming
or INITiate.
L
The actual number of measurements made on each INIT is equal to:
(:ARM:START:COUNT)*(:TRIG:START:COUNT)
Parameters:
<Numeric value> is an integer between 1 and 2 147 483 647 (2
31
-1). (The integer 1 switches
the function OFF.)
MIN gives 1
MAX gives 2 147 483 647
* CNT-91 only: INFinity makes the arm loop continue indefinitely, or rather until other de-
vice-dependent parameters set limits. In practice, timestamping will probably collapse
after more than 100 days of non-aborted operation. The INFinity parameter is mainly
intended for continuous measurements, i.e. without defined end, where intermediate re-
sults can be fetched on the fly.
Returned format: <Numeric value>|INF*
Example:
SEND®
:ARM:COUN8100¿
*RST condition: 1
Complies with standards: SCPI 1991.0, confirmed

Table of Contents

Other manuals for Pendulum CNT-91R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pendulum CNT-91R and is the answer not in the manual?

Pendulum CNT-91R Specifications

General IconGeneral
BrandPendulum
ModelCNT-91R
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals