EasyManuals Logo

Pendulum CNT-91R Programmer's Handbook

Default Icon
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #232 background imageLoading...
Page #232 background image
8-124 Command Reference
:TRIGger :COUNt
8 «<Numeric value> | MIN | MAX»
No. of Triggerings on each Ext Arm start
Sets how many measurements the instrument should make for each ARM:STARt
condition, (block arming).
These measurements are done without any additional arming conditions before the
measurement. This also means that stop arming is disabled for the measurements
inside a block.
+
The actual number of measurements made on each INIT equals to:
(:ARM:START:COUN)*(:TRIG:START:COUNT)
Parameters:
<Numeric value> is a number between 1 and 16777215 (2
24
-1).
MAX gives 16777215
MIN gives 1
Example:
SEND®
:TRIG:COUN 8 50
Returned format: <Numeric value>¿
*RST condition: 1
Complies with standards: SCPI 1991.0, confirmed.
:TRIGger :SOURce
8TIMer | IMMediate
Pacing
Enables or disables the pacing function, i.e. the sample rate control. The pacing
time is set by the :TRIG:TIM command.
Parameters:
TIMer - enables pacing
IMMediate - disables pacing
*RST condition: IMM

Table of Contents

Other manuals for Pendulum CNT-91R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pendulum CNT-91R and is the answer not in the manual?

Pendulum CNT-91R Specifications

General IconGeneral
BrandPendulum
ModelCNT-91R
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals