Pendulum CNT-91R - Page 80

PRF
Select Pulse Repetition Frequency measurement via the
- MEAS  Pulsed RF  Repetition  PRF  C.
Set corresponding measurement settings in the following menus:
-
SETTINGS

Pulsed RF

Sensitivity.
- SETTINGS  Misc  Input C Acq  Center frequency
4-32
USER MANUAL ● CNT 9x Series ● Rev.22 February 2020
- SETTINGS  Pulsed RF  Sensitivity.
- SETTINGS

Misc

Input C Acq

Center frequency
The Negative Duty Factor corresponds to the negative pulse width
divided by the Pulse Repetition Interval.
Measuring Functions
P ULSE W IDTH POS
Select Positive Pulse Width measurement via the
- MEAS → Pulsed RF → Width → Pos → C.
Set corresponding measurement settings in the following menus:
- SETTINGS → Pulsed RF → Sen sitivity.
- SETTINGS
→
Misc
→
Input C Acq
→
Center frequency
P ULSE W IDTH NEG
Select Negative Pulse Width measurement via the
- MEAS
→
Pulsed RF
→
Width
→
Neg
→
C.
This measure corresponds to pulse off width, or the time between
pulses.
Set corresponding measurement settings in the following menus:
- SETTINGS
→
Misc
→
nput C Acq
→
Center frequency
DUTY F AC
TOR POS
Select Positive duty factor measurement via the
- MEAS →Pulsed RF →Width →Duty Factor Pos →C.
Set corresponding measurement settings in the following menus:
- SETTINGS  Pulsed RF  Sensitivity.
- SETTINGS

Misc

Input C Acq

Center frequency
Positive Duty Factor corresponds to the pulse width divided by the
Pulse Repetition Interval.
DUTY F ACTOR NEG
Select Negative duty factor measurement via the
- MEAS → Pulsed RF → Width → Duty Factor Neg → C.
Set corresponding measurement settings in the following menus:
P OWER ON
CNT-90XL option 28 is also able to measure the power within pulses
by selecting the function in the appropriate menu:
- MEAS → Pulsed RF → Power ON → C
Set corresponding measurement settings in the following menus:
- SETTINGS

Pulsed RF

Start Delay.
- SETTINGS  Pulsed RF  Measurement Time.
-
SETTINGS  Misc  Input C Acq  Center frequency