What to do if Pentair AUTOTROL 368 drips water after regeneration?
If you observe flowing or dripping water at the drain or brine line after regeneration in your Pentair Control Unit, it could be because debris is preventing the #3 or #4 valve disc from closing. Remove the debris. Alternatively, the #3 or #4 valve disc might be worn and need replacement.
Why Pentair AUTOTROL 368 Control Unit runs out of conditioned water between regenerations?
If you run out of conditioned water between regenerations with your Pentair Control Unit, the controller might be improperly programmed. Verify the salt dosage and regeneration interval settings.
What causes brine tank overflow in Pentair Control Unit?
If your Pentair Control Unit is overflowing the brine tank, ensure all brine line connections are tight. Also, the drain line might be restricted with debris; clean the drain controller.
Why Pentair AUTOTROL 368 backwashes at excessively low rate?
If your Pentair Control Unit is backwashing or purging at an excessively low or high rate, it might be due to an incorrect drain controller being used. Replace it with the correct size controller. Another cause could be the absence of a drain line flow controller; install a drain line flow controller. A restricted drain line could also be the culprit; remove the restriction.
Why is there intermittent brine draw in my Pentair AUTOTROL 368 Control Unit?
If your Pentair Control Unit is experiencing intermittent brine draw, it could be due to low water pressure. Maintain a minimum pressure of 1.3 bar (20 psi).
Why flow indicator on Pentair AUTOTROL 368 Control Unit does not display service flow?
If the flow indicator on your Pentair Control Unit isn't displaying service flow, it could be because the bypass valve is in the bypass position. Remove the bypass valve from the bypass position. Another potential cause is the meter cable being dislodged from the valve; fully insert the meter cable into the valve. Lastly, the meter might be clogged with debris, in this case, remove and clean the meter.
Why is there no conditioned water after regeneration in my Pentair AUTOTROL 368 Control Unit?
If your Pentair Control Unit has no conditioned water after regeneration, it could be due to a lack of brine in the brine tank. Make sure to add brine to the brine tank. Alternatively, the injector might be plugged; clean the injector and screen.
What to do if Pentair AUTOTROL 368 Control Unit will not draw brine?
If your Pentair Control Unit isn't drawing brine, it might be due to a restricted drain line, so remove the restriction. Another possibility is a plugged injector; clean the injector and screen. Also, check if any debris is preventing the valve discs from closing and remove any foreign matter.
What to do if Pentair AUTOTROL 368 will not regenerate automatically?
If your Pentair Control Unit isn't regenerating automatically, ensure the AC adapter or motor is properly connected. If connected, but the issue persists, the motor might be defective and need replacement. Another potential cause is a meter clogged with debris. In this case, remove and clean the meter.
What causes Pentair AUTOTROL 368 Control Unit to backwash or purge at an excessively low or high rate?
General| Model | AUTOTROL 368 |
|---|---|
| Type | Control Unit |
| Control Type | Electromechanical |
| Electromechanical | Yes |
| Power Supply | 120/240V AC |
| Voltage | 120/240V AC |
| Frequency | 50/60 Hz |
To Next Page
