Installer Manual Autotrol 368 / 604-606 - Installation
Ref. MKT-IM-007 / A - 16.12.2016 23 / 54
5.6. Connections (electrical)
5.7. Drain line flow controller
The DLFC requires assembly before use.
Note
The plumbing connectors should not be installed. See 5.8.1. Bypass assembly, page 24.
A Using a PTFE (plumber’s tape), wrap it over threads of the flow controller (2).
B Screw the flow controller (2) and the 90° elbow (1) together (hand tighten).
C Place the ball (5) into the flow controller (2) and insert the assembly into the drain line opening
(4).
D Push the assembly in and secure with the drain line clip (3).
Motor and optical sensor cable connection
Meter cable connection (368 / 606 only)
AC adapter connection
AC adapter cable connection
A
To Next Page
Loading...
