Installer Manual Autotrol 368 / 604-606 - Programming
28 / 54 Ref. MKT-IM-007 / A - 16.12.2016
6. Programming
Note
After 5 seconds without keypad input, the unit returns to normal operation mode and display
the time of day.
Note
Memory retention in case of power failure : the controller stores the time of day without
battery in case of power failure. All others programmed parameters are stored in the non-
volatile (Novram) memory and are stored during power failure. The storage time in the flash
memory is about 99 years.
Note
has two different functions according to the controller used :
For 604 controllers : the function is the day interval setting.
For 606 controllers : the function is the volumetric capacity setting.
6.1. Time of day
Set the current time.
6.2. Brine dosage
Set the brine dosage.
A Press until desired hour appears then release.
→ Range from 0 through 23 hours.
→ The elapsed minutes will reset to zero when the hours are
changed.
A Press until desired brine dosage appears then release.
→ Range from 0.2 kg to 6.0 kg;
from 0.2 kg to 1.0 kg by increments of 0.05 kg;
from 1.0 kg to 3.0 kg by increments of 0.1 kg;
from 3.0 kg to 6.0 kg by increments of 0.5 kg.
To Next Page
Loading...
