Pentair AUTOTROL 604 - Removing the Manifold; Bypass

Installer Manual Autotrol 368 / 604-606 - Maintenance
Ref. MKT-IM-007 / A - 16.12.2016 41 / 54
f
9.2.5. Removing the manifold / bypass
Note
Depending on the installation configuration, the valve may be equipped with a manifold or a
bypass. The following procedure applies to both configuration.
No. Operation
A Remove the "U" clips (1) (a screwdriver can be used as a lever if required).
B Remove the manifold / bypass (2) from the valve body (3).
A