Pentair AUTOTROL 604 - To Advance Regeneration Cycles; To Cancel a Regeneration

Installer Manual Autotrol 368 / 604-606 - Operation
36 / 54 Ref. MKT-IM-007 / A - 16.12.2016
8.3. To advance regeneration cycles
A Simultaneously press and to advance to the next cycle.
→ When the camshaft reaches the next cycle, "C#” will be displayed.
B Repeat and to advance through each cycle.
8.4. To cancel a regeneration
A Press and hold and for 3 seconds during any regeneration cycle to cancel it.
→ The controller will skip the remaining regeneration cycles and return to the service position.
It may take 1 to 2 minutes.
→ The time of day will be displayed when the controller reaches the service position.