Installer Manual Autotrol 368 / 604-606 - Programming
Ref. MKT-IM-007 / A - 16.12.2016 31 / 54
6.8. History values
The controller features a review level that displays the operation history of the system. To access
history values :
Note
When is pressed to view H2 history, the current flow rate will be displayed but not
updated. Continue to press and release every 5 seconds to update the display. The flow
dot on the display will flash when there is flow through the turbine.
Note
After 30 seconds without a button press, the controller exists the history table.
A Press and hold and simultaneously for 3 seconds.
→ To view the "H" levels.
B Press to navigate through the table.
→ When the desired code is reached, press to display the
value.
→ Some of the values have four digits. Press to display the
first two digits, then press to display the last two digits.
Code Description Notes
H1 Days since last recharge Days since last recharge
H2 Current flow rate Liter per minute
H3 Current day of week Current day of week
H4 Water used today since 02h00
In liters,
max value displayed 9999
max value stored 65 535
A0 Average water usage for day 0
A1 Average water usage for day 1
A2 Average water usage for day 2
A3 Average water usage for day 3
A4 Average water usage for day 4
A5 Average water usage for day 5
A6 Average water usage for day 6
To Next Page
Loading...
