Installer Manual Fleck 2910 - NXT - Installation
52 / 114 Ref. MKT-IM-002 / B - 23.05.2018
5.10. Bypassing
A bypass valve system should be installed on all water conditioning systems. Bypass valves isolate the
softener from the water system and allow unconditioned water to be used. Service or routine
maintenance procedures may also require that the system is bypassed.
Caution
Do not solder pipes with lead-based solder.
Caution
Do not use tools to tighten plastic fittings. Over time, stress may break the connections.
Caution
Do not use petroleum grease on gaskets when connecting bypass plumbing. Use only 100%
silicone grease products when installing any plastic valve. Non-silicone grease may cause
plastic components to fail over time.
5.11. Drain line connection
Note
Standard commercial practices are expressed here. Local codes may require changes to
the following suggestions. Check with local authorities before installing a system.
Mandatory
The drain line must be build with 1" PVC rigid tube with an air gap must be present at the
drain.
Caution
Flexible and semi-flexible hoses may bend and whip during draining.
In Bypass
In InOut Out
Softening
System
Softening
System
Normal
operation
To Next Page
Loading...
