Installer Manual Fleck 2910 - NXT - Maintenance
90 / 114 Ref. MKT-IM-002 / B - 23.05.2018
9.2.8. Injector cleaning
No. Operation
A Using a 8 mm and a 20 mm wrench, unscrew the screws (1) and the brine valve nut (2).
B Using flat screwdrivers, remove the injectors (5) and (6) from injector body (8).
C
Clean the injectors (5) and (6) and the filter (7) using compressed air, a soft brush or
possibly a pin.
D Lubricate on the gaskets (4) and (9) using silicone grease.
E Assemble as shown the injector in the valve body (10).
F Reverse above procedure steps to rebuild.
To Next Page
Loading...
