Installer Manual Fleck 2910 - NXT - Maintenance
86 / 114 Ref. MKT-IM-002 / B - 23.05.2018
9.2.6. Upper piston and/or seal and spacer kit replacement
Caution
Use only approved silicone grease or soapy water.
9.2.6.1 Special tools needed
No. Operation
A Using a flat screwdriver, unscrew (1) and open the cover (2).
B Using pliers, remove the connecting pin (3).
C Using a flat screwdriver, unscrew (4) and remove the motor assembly (6).
D
Using a 22 mm wrench, unscrew the brine valve nut (7) and remove the upper power head
(5).
E Using pliers, remove the piston (10).
F Using a small hook, remove an upper seal (9).
G Using the puller, remove an upper spacer (12).
H Repeat G and H for all the seals and spacers.
I Put back the first new spacer (8) using the stuffer.
J Lubricate each new seals (9).
K Put back a seal (9) using the stuffer.
L Put back a spacer (12) using the stuffer.
M Repeat M and N for all the seals and spacers.
N Lubricate the piston o-ring (11).
O Put back the piston (10).
P Follow A to D in reverse order to rebuild.
Item Part number Description
Packaging
quantity
1 13061 Puller 1
2 11098 Stuffer 1
To Next Page
Loading...
