Pentair FLECK 2910 NXT - Parameters Saving; Diagnostic; Commands; Current Flow Rate

Installer Manual Fleck 2910 - NXT - Programming
72 / 114 Ref. MKT-IM-002 / B - 23.05.2018
6.5.21. Parameters saving
Note
When the last parameter is set and the button pressed, the controller updates the
database based on the new programming. Wait until programming is finished, this may take
a few seconds.
6.6. Diagnostic
Note
Depending on current settings, some displays cannot be viewed.
Note
There is no time limit on the displays in the Diagnostic mode.
6.6.1. Commands
6.6.2. Current flow rate
Note
The display is updated every second.
6.6.3. Peak flow rate
Note
The controller registers the highest flow rate since the last regeneration.
PROGRAMMING UNIT
PLEASE WAIT...
A Press D to enter the Diagnostic mode.
B Press to pass at the next step.
C Press D to exit the Diagnostic mode at any time.
CURRENT FLOW RAT
L/min 0Lpm
PEAK FLOW RATE
0Lpm