24
25
IntelliSync Control and Monitoring System User's Guide
Before testing the wireless signal strength, be sure to Bluetooth®
wireless technology pair with your wireless mobile or desktop device.
See page 6.
1. Follow the instructions given on page 4, Pairing to a Wireless Network.
2. The CONNECTION LED will temporarily blink green when power is
applied to the IntelliSync unit. After a few seconds the Connection LED
will either be:
BLINKING GREEN: Indicates IntelliSync is in access point mode and has
not yet established a connection with the router.
SOLID GREEN: Indicates a successful wireless connection between
IntelliSync and the home router has been established. Proceed to Step
4.
BLINKING RED: Indicates an unsuccessful wireless connection to
IntelliSync and that access point mode has timed out. Power down the
IntelliSync unit for 10 seconds to reset access point mode and proceed
to Step 2 for recommendations on improving the signal/connection
strength.
Note: Ensure the router security key entered. Tap the Connect button
(see Step 6, page 4) continuing to Step 2. Entering an incorrect router
security key will result in an unsuccessful connection.
Note: IntelliSync drops a wireless connection, it may take up to 3
minutes before the Connection LED begins to blink red.
3. If the wireless signal from the router is not strong enough to
successfully pair with the IntelliSync unit, the signal strength may be
improved by:
• Moving the router to an area that minimizes the distance and
obstructions between it and the enclosure.
• Repositioning the enclosure so that the distance and
obstructions between it and the home network wireless router
are minimized.
• Purchasing and installing a wireless range extender to bridge
the wireless signal between the home router and IntelliSync
unit.
4. Continue to test the signal strength until the CONNECTION LED turns
solid green.
Note: IntelliSync must be powered down for a minimum of 10 seconds
before it will enter access point mode (blinking green CONNECTION LED).
Testing Wireless Signal Strength
To Next Page
Loading...
Need help?
General
