118
3
Taking Pictures
4
Use the four-way controller (23)
to change the sensitivity.
5
Press the 4 button.
The setting is saved.
6
Press the 3 button.
The camera returns to capture status.
This specifies whether Blink Detection function works when you use the
Face Recognition function. The default setting is O (On).
1
Press the 3 button in A mode.
The [A Rec. Mode] menu appears.
2
Use the four-way controller (23) to select [Blink
Detection].
• When the sensitivity is set to 3200 or 6400, the number of recorded
pixels is fixed at f (2592×1944).
• When set to 9 (Green), C (Movie) or V (Underwater Movie) mode,
only Auto (sensitivity 64 - 800) is available.
• When set to c (Digital SR) mode, only Auto (sensitivity 64 - 6400) is
available.
• When set to S (Fireworks) mode, the sensitivity is fixed at its
minimum setting.
• If you change the [Sensitivity] setting frequently, you can save time by
assigning it to the Green button (p.124).
Saving the Sensitivity setting 1p.133
Setting Blink Detection
OKMENU
1/4
400
200
100
64
Auto
Rec. Mode
Cancel OK
Recorded Pixels
Pixel Track SR
White Balance
AE Metering
Sensitivity
Focusing Area
To Next Page
Loading...
