Pentax Optio WS80 - Recording a Movie from Pictures Taken at a Set Interval (Interval Movie)

130
3
Taking Pictures
In k (Interval Movie) mode, you can record multiple still pictures taken
at a certain interval from a set time, and save them as a movie file.
Specify the following settings.
1 Press the four-way controller (3) in A mode.
The Capture Mode Palette appears.
2 Use the four-way controller (2345) to select C
(Movie) or V (Underwater Movie).
3 Press the four-way controller (2).
The [Drive Mode] screen appears.
4 Use the four-way controller (45)
to select k and press the 4
button.
The current settings for interval shooting
appear for approximately 1 minute. To
record movies with the current settings,
proceed to Step 12.
Recording a Movie from Pictures Taken at a Set
Interval (Interval Movie)
Interval
You can set the interval to 1 minute, 5 minutes, 10 minutes, 30
minutes or 1 hour.
Total Time
Set the total recording time from 10 minutes to 359 hours. The total
time and settable units (p.128) vary depending on the [Interval] setting
and movie frame rate (p.132).
Start Delay
Set the start delay from 0 minutes to 24 hours. The start delay can be
set in increments of 1 minute for a delay time up to 59 minutes, and
increments of 1 hour for a delay time longer than one hour. When set
to 0 min., the first picture is taken as soon as the shutter release
button is pressed.
OK
O KO K
OK
I n te r v a l S h o otI n te r v a l S h o ot
Interval Shoot
D r iv e M od eD r iv e M od e
Drive Mode
MENU
C a nc e lC a nc e l
Cancel