74
3
Taking Pictures
1
Press the four-way controller (4)
in A mode.
The [Flash Mode] screen appears.
The flash mode changes each time the
button is pressed. You can also change the
setting using the four-way controller (23).
In (Underwater) mode, (Flash Off +
Flash On (2 shots)) appears instead of c
(Auto + Red-eye) and d (Flash On + Red-
eye) as shown on the right.
When you select (Flash Off + Flash On
(2 shots)), two images are taken in
succession in a (Flash Off) and b (Flash
On). After taking the pictures, you can
select the best shot from them.
2
Press the 4 button.
The setting is saved and the camera returns to capture mode.
About the red-eye phenomenon
Taking pictures using the flash may cause the subject’s eyes to appear red in the
resulting picture. This phenomenon occurs when the light from the flash is reflected
in the subject’s eyes. It can be reduced by increasing the illumination in the area
around the subject and/or decreasing the subject distance and adjusting the lens to
wider angle setting. Setting the flash mode to c (Auto + Red-eye) or d (Flash On +
Red-eye) is also an effective way of reducing red eyes.
If the subject’s eyes appear red despite such precautions, they can be corrected by
the Red-eye Edit function (p.137).
Saving the Flash Mode setting 1p.108
MEN
MENU OK
OK
OKCancel
Cancel
Flash Mode
Auto
Flash Mode
Auto
MEN
MENU OK
OK
OKCancel
Cancel
Flash Mode
Flash Off+Flash On
(2 shots)
Flash Mode
Flash Off+Flash On
(2 shots)
e_kb635_EN.book Page 74 Thursday, November 9, 2023 9:17 AM
To Next Page
Loading...
Need help?
General
