84
3
Taking Pictures
4
Press the 4 button.
The setting is saved and the screen returns to the [A Rec. Mode] menu.
You can set the area of the screen where the brightness is metered to determine
the exposure.
1
Use the four-way controller (23) to select [AE Metering] in
the [A Rec. Mode] menu.
2
Press the four-way controller (5).
A pull-down menu appears.
3
Use the four-way controller (23) to select a metering
method.
4
Press the 4 button.
The setting is saved.
Setting the AE Metering
L
Multi-segment
metering
The camera divides the screen into 256 areas, meters the
brightness and determines the exposure.
M
Center-
weighted
metering
The camera takes a reading of the overall brightness of the
screen with the center of the screen having more influence
on the exposure.
N
Spot AE
metering
The camera determines the exposure by metering the
brightness only at the center of the screen.
• When the shutter release button is pressed halfway, the brightness is
metered and the exposure is determined.
• When the subject is not at the center of the screen and you want to use the
Spot AE metering, center the subject on the screen and press and hold the
shutter release button halfway to lock the exposure, then compose your
picture again and press the shutter release button fully.
• The AE Metering setting may not be changed depending on the selected
shooting mode. Refer to “Functions Available for Each Shooting Mode”
(p.172) for details.
Saving the AE Metering setting 1p.108
e_kb635_EN.book Page 84 Thursday, November 9, 2023 9:17 AM
To Next Page
Loading...
Need help?
General
