10
1.5 Touch screen calibration
When you operate on the screen, if your device isn’t responding to you taps, you
may need to recalibrate your screen. In any picture, press the combination key
“CTRL+TAB” so as to enter into touch screen calibration. The calibration
process is shown in the figure below.
1) Carefully press and briefly hold stylus
on the center of the target. Repeat as
the target moves around the screen.
2) After all the targets are clicked, th
screen will display as left, tap th
screen to register saved data. Th
screen goes back to Stylus Properties
menu.
1.6 Battery
1.6.1 Battery Power indicator
At any screen, press【★】key to open
fast setting menu.
Select Battery, battery level will b
seen following
Battery Level
.
To Next Page
Loading...
