IC-KP-B17-AIDA1
Web features
2014-02
99
Use client filter, IP address:
When the client filter is active, only the network client specified under IP address can exchange
data with the server. Web access is still possible, however.
8.5 Exchanging identification data
For commissioning purposes, you can use this link to activate an applet for executing the
following identification commands:
■
CT - change tag
■
EF - enhanced buffered read fixcode
■
ER - enhanced buffered read words
■
EW - enhanced buffered write words
■
EX - enhanced buffered write fixcode
■
QU - quit
■
SF - single read fixcode
■
SW - single write words
■
SX - single write fixcode
■
SR - single read words
■
TM - set triggermode
■
MM - set multiplexed mode
Communication with the identification system is only possible if no connection has been
established between the device and a controller, for example.
Command:
Selection field for the identification commands. More input boxes may be available depending
on the command. An entry is suggested for each command. Refer to the command description
() for an explanation of the meaning.
Channel (in the second line):
The channel number of the response telegram appears in this field.
To Next Page
Loading...
