IC-KP-B17-AIDA1
Commands
2014-02
57
7.7 Command types
When using commands, a distinction is always made between the two command types single
mode and enhanced mode.
Single mode
The command is executed once. A response is issued immediately.
Enhanced mode
The command remains permanently active until it is interrupted by the user or by an error
message. A response is issued immediately.
The command remains active after the response is issued. Data is only transferred if read/write
tags change. Read/write tags are not read twice. If a read/write tag leaves the read range, the
status '5' is output.
7.8 Command Overview
The commands in the list are described in detail on the following pages.
System commands
Standard read/write commands
Read only code
Read data
Write data
Command code Command description
Abbre-
viation
4d 04h See "change tag (CT)" on page 59 CT
2d 02h See "quit (QU)" on page 62 QU
23d 17h See "configuration store (CS)" on page 63 CS
22d 16h See "reset (RS)" on page 64 RS
155d 9Bh See "set multiplexed mode (MM)" on page 64 MM
156d 9Ch See "set trigger mode (TM):" on page 65 TM
Command code Command description
Abbre-
viation
1d 01h See "single read fixcode (SF)" on page 66 SF
29d 1Dh See "enhanced buffered fixcode (EF)" on page 67 EF
Command code Command description
Abbre-
viation
16d 10h See "single read words (SR)" on page 68 SR
25d 19h See "enhanced buffered read words (ER)" on page 69 ER
Command code Command description
Abbre-
viation
64d 40h See "single write words (SW)" on page 70 SW
26d 1Ah See "enhanced buffered write words (EW)" on page 71 EW
To Next Page
Loading...
