2023-05
22
VisuNet Control Center 6
Manage (Home)
Performing a Group Action via Wizard
Perform Group Action via List View
Perform an action for a device group. Select your required devices by using one of the following
methods:
1. Switch to "List View" mode.
2. Select one or more RMs / BTCs from your list of devices.
Figure 6.6 Selecting RMs for group actions
3. Switch to “Tile View” mode.
Figure 6.7
4. Select one or more RMs / BTCs by holding down the Ctrl key and click any device you would
like to add.
5. Perform the same selection procedure within the static or dynamic groups.
To Next Page
Loading...
