VisuNet Control Center 6
Manage (Home)
2023-05
21
Dynamic Groups
Dynamic groups allow you to filter your list of RMs / BTCs based on their current online status.
To add a dynamic group, click “Add Dynamic Group” on the ribbon tool bar. You must assign it a
name, and you can select which online statuses you would like to see when viewing the
dynamic group. To keep a dynamic group, you must save the project.
Figure 6.4 Create dynamic group window
6.2 View
Depending on your required actions either chose List View or Tile view. In both views multiple
devices can be selected. Double click a device in either view or in the navigation menu to
switch from device group view to device detail view.
6.3 Programm Apperance
The Programs appierance can be changed from the default dark theme to a light one.
6.4 Group Actions
Group actions allow you to perform actions on multiple devices with only one time set-up. This
allows remote, multi device management which decreases set up times and therefore costs.
All group actions are performed via a wizard, which guides you through the single steps of your
action. The wizards support you when down- or uploading multiple device settings, shutting
down or restarting multiple devices, update multiple devices with a newer firmware or cleanup
the disk of multiple devices.
Figure 6.5
To Next Page
Loading...
