PerkinElmer IVIS Lumina XRMS III Series

Appendix A XWS-260 Workstation
Shutting Down the Imaging System on page 78
Moving the Imaging System on the XWS-260 Workstation on page 78
Starting the Imaging System on page 78
This appendix explains how to move the IVIS Lumina XRMS Series III configured with the XWS-
260 workstation (Figure A.1).
The procedural steps include:
 Shut down the system components and unplug them from the line power.
 Move the workstation with the components.
 Restart the system components after the power is restored.
!
CAUTION: PerkinElmer recommends that you do not move an IVIS Lumina XRMS
Series III that is not located on the XWS-260 workstation. If you need to move an
imaging system not on the workstation, contact PerkinElmer Technical Support
for assistance (see page 24).
!
CAUTION: The IVIS Lumina XRMS Series III has many cables and lines. It is very
important to closely follow all directions to avoid damaging the system
components.
Figure A.1 IVIS Lumina XRMS Series III Configured with XWS-260 Workstation