Controls
22
Single zigzag
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, the standard “single zigzag“ pattern is sewn, see Chapter 10.02.02 Zig-
zag stitches.
Two-stitch zigzag
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, the standard “two-stitch zigzag“ pattern is sewn, see Chapter 10.02.02
Zigzag stitches.
Three-stitch zigzag
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, the standard “three-stitch zigzag“ pattern is sewn, see Chapter 10.02.02
Zigzag stitches.
Right/left shell stitches
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, it is possible to choose and sew one of 4 patterns, see Chapter 10.02.03
Shell stitches.
Right/left blind stitches
If this key is pressed, the corresponding function is switched on or off. When the function
is switched on, the standard “right blind stitch“ or “left blind stitch“ pattern is sewn, see
Chapter 10.02.04 Blind stitches.
PM
If this key is pressed, the function for sewing programmed seam patterns is switched on
or off. The parameters for the specifi c program are shown in the alphanumerical section
of the display.
Menü
Press this key to scroll through the input menus.
TE/Speed
Press this key once in the sewing mode to call up the input menu for the maximum
speed. If there is no input within 5 seconds, the sewing mode is called up again.
Press this key twice (within 5 seconds) in the sewing mode to change to the parameter
input function.
By pressing this key when in the parameter input function, the altered values are stored
and the sewing mode is called up.
●
●
●
●
●
●
●
●
●
●
To Next Page
Loading...
Need help?
General
