Installation and commissioning
29
8.02 Commissioning
Check the machine, especially the electrical leads, for any damage.
Clean the machine thoroughly (see chapter 11 Care and maintenance).
Have specialists ensure that the machine’s motor can be operated with the available elec-
tricity supply and that it is connected properly. If not, the machine must not be operated..
When the machine is running, the balance wheel must turn towards the operator. See
Chapter 8.04 Basic position of the machine drive unit.
●
●
●
●
Before commissioning the machine, remove cap 1 and plug 2 and fi ll in oil up to
marking 3, see Chapter 11.03 Oiling the machine.
Close the hole again with plug 2.
Cap 1 is used as a transport lock and must not be fi tted during operation!
8.03 Switching the machine on/off
Switch the machine on (see Chapter 7. 0 1 On/Off switch).
Carry out a test run.
●
●
●
●
Fig. 8 - 08
1
2
3
To Next Page
Loading...
Need help?
General
