Sewing
43
8.0 +0.0
Change the value for the zigzag stitch width by pressing the corresponding +/- key.
Change the stitch position value by pressing the corresponding +/- key.
●
●
10.02.02 Zigzag stitches
Switch on the machine.
Call up the standard pattern for "single zigzag", two-stitch zigzag" or "three-stitch zigzag.
●
●
10.02.03 Shell stitches
Switch on the machine.
Call up the standard pattern for "right shell stitches" or "left shell stitches".
●
●
ZZ
1A 8.0 +0.0
Call up the desired seam pattern by pressing the corresponding +/- key:
Value "1": 24-stitch standard shell stitch
Value "2": 24-stitch crescent-shaped shell stitch
Value "3": 24-stitch constant width shell stitch
Value "4": 12-stitch constant width shell stitch
If there is an "A" after the value, the selected seam pattern being sewn is then
sewn in reverse, see Chapter 10.04 Mirror imaging shell stitches and pro-
grammed seam patterns.
Change the value for the zigzag stitch width by pressing the corresponding +/- key.
Change the value for the stitch position by pressing the corresponding +/- key.
●
●
●
ZZ
To Next Page
Loading...
Need help?
General
