Adjustment
11 - 70
6 601 Cut
l = yes l
ll = no
607 Max. speed 100 - 2800 2800
609 Cutting speed 1 30 - 300 180
7 700 Needle position 0 - 191
Needle reference position
701 Angle setting
I = Set synchronizer with l
balance wheel
II = Set synchronizer with
buttons " + " and " - "
702 Needle position 1 (needle lowered) 0 - 191 20
703 Needle position 2 0 - 191 175
(take-up lever raised)
707 Needle position 9 0 - 191 140
(Start tension release signal 2)
11.10 Parameter settings for the Quick-Ministop Motor
Parameters can be set on the operating panel via display.
Group
Parameter
Significance Setting Standard value
Further displays and information are available in the Motor Service Manual.
To Next Page
Loading...
