Adjustment
17
● Set feed regulator levers 6, 7 and 8 at "0".
● Fit adjustment link 9 onto pins 10.
● Rotate the balance wheel and turn crank 11 (screw 12) so that the vibrating presser no
longer moves.
● Loosen nut 1.
● Move linkage 14 up and down several times, and while doing so adjust lever 16
(screw 15) so that the vibrating presser no longer moves.
● Set linkage 14 at the top end of the elongated hole and tighten nut 1.
● Set feed regulator levers 6, 7 and 8 at "3".
● Move crank 17 axially and radially against crank 18 and tighten screw 1.
● Remove adjustment link 9.
● Push feed regulator levers 6, 7 and 8 fully to the top.
● Set a clearance of 0.5 mm between reverse-feed lever 21 and actuating levers 19 and 20
and tighten screw 3.
Fig. 1 - 13
12
11
15
To Next Page
Loading...
Need help?
General
