Adjustment
9
● Set feed regulator lever 1 in its lowest position.
● Turn bush 2 (screw 3) so that mark 4 is facing downwards and the edge of the milled
surface is at an angle of approx. 45° to the front side of the machine.
(For the fi nal adjustment, see Chapter 1.0.06.16 "Top feed synchronization".)
● Turn crank 5 (screw 6) according to Requirement.
1.06.04 Adjustment with the gearcase opened
Fig. 1 - 05
5
6
45
°
2
3
4
1
To Next Page
Loading...
