2:10
C
D
Place the thread from left to right through the take-up lever D.
Important: The take-up lever must be at its highest position.
Winding the bobbin through the needle
It is possible to wind the bobbin even when the machine is fully
threaded.
Raise the presser foot to the up position. Pull the needle thread under-
neath the presser foot and upward through the right-hand threader
slot.
Guide the thread to the right under thread guide C.
Place an empty blue bobbin on the bobbin winder
aligning the small rectangular hole on the bottom
side of the bobbin with the small pin of the bobbin
winder. The Pfaff logo is facing up. Push the bobbin
to the right.
Wind the thread tail clockwise several times around
the bobbin. Turn on the machine. Hold the thread
tail fi rmly and press the foot control.
As soon as the bobbin is full, the winding action will
be stopped automatically. Push the bobbin to the
left, cut the thread and remove the bobbin from the
winder.
To Next Page
Loading...
