102
48. Programmed patterns
This is a selection of special patterns for purposes of adjusting the sewing machine.
49. Options for messages
• Switch on the machine.
• Touch the „Info“ button until the „Context menu“ appears.
• Touch the „Options for messages“ button.
• Select your settings and then press the „OK“ button.
The settings are saved.
The machine switches automatically over to the welcome screen.
50. Erasing machine memory
If the „0-9“ button is pressed when the machine is switched on, the entire internal memory is erased.
This erases all machine settings as well as stored pattern sequences.
Now the machine is set to a factory setting.
51. Demonstration (Pattern flow)
• Switch on the machine.
• Touch the „Info“ button until the „Context menu“ appears.
• Press the lower cursor button to browse through the display for the Machine test.
• Touch the „Machine test“ button.
• Enter the code 254.
• Confirm the input with the „OK“ button.
• Touch the „Pattern flow“ button.
By pressing on the „Pattern flow“ button, the machine is switched to the demo mode in which all
patterns are automatically selected („display-window demonstration“).
The demo mode is also active when the machine is restarted.
This status can only be switched off permanently here.
• To interrupt demo, press the „Main menu“ button; it is now possible to sew with the machine.
Machine test
The machine test menu is reached via the „Main menu“ in the „Context menu“ by entering an access
code (254).
Only those tests which can be performed by the software or have to be controlled by it are described here.
A test should only be launched if the involved assemblies have already been successfully tested.
For example:
The machine motor must be turning in order to test the amount of thread on the bobbin; the machine motor
should therefore be tested before testing the amount of thread on the bobbin.
To Next Page
Loading...
Need help?
General
