1. Important Notes for Your Safety
☞ Read and follow up all information given in these
instructions.
☞ Inform yourself about:
– Hazards caused by the unit.
– Hazards caused by your system.
☞ Note the safety and accident prevention regulations.
☞ Regularly check compliance with all safety measures.
☞ Install the TCP 3000 while maintaining the specified
ambient conditions.
☞ System of protection is IP 20. The unit is protected against
being penetrated by foreign objects exceeding a diameter
of 12 mm. There is no protection against entering water,
for this reason the unit must be installed in a suitable case
(see Chapter 3 – Installation).
☞ Never convert or modify the unit on your own.
☞ During operation or in the event of a fault condition never
disconnect any cables connected at the TCP.
☞ After a mains power failure and after mains power returns,
the pump will start up automatically.
☞ Make sure that the insulation of the cables is undamaged.
☞ Never remove the cover of the casing while mains power
is applied or while the pump is running.
☞ Note the voltage specifications when connecting the
cables to the various plugs.
☞ Make sure that the cables are laid correctly so that the
possibility of damaging the cables can be excluded. Never
lay cables over sharp edges or across hot surfaces.
☞ Always operate the unit within the specified voltage range
(see also Chapter 3.4).
☞ The unit must not be operated as a bench top unit without
the covers in place.
☞ Via the mains connection a reliable connection to the
ground wire (PE) must be ensured (German Protection
Class 1).
☞ Protect the unit against being thermally overloaded.
☞ Never disconnect any connectors at the unit or at the
turbomolecular pump while running or before the pump
has stopped completely.
☞ When returning the unit, note our shipping information first
(Chapter 9).
Warning, risk of suffering injury.
To Next Page
Loading...
