PFlow Industries D116 User Manual

Revision: 3.0.3
Totalizer Reset
Totalizer reset; all parameters are reset. Press
press or arrow to select "YES"
After "YES"
is selected, the following options are
available:
None:No reset;
All:Reset all totalizers;
NET Totalizer Reset;
POS Totalizer Reset;
NEG Totalizer Reset;
Reset:back to the factory default
If the user wants
to delete all the already set
parameters and set back to the factory
default, select
reset in this window and then the
flow meter
to be the factory default automatically.
Manual Totalizer
The manual totalizer
is a separate totalizer. Press
to start, and press
to stop it. It is used for flow
measurement and calculation.
Damping Factor
The damping factor ranges from 0～
999 seconds.
indicates no damping; 999 indicates
the maximum
damping.
The damping function will stabilize the flow display.
Its principle is the same as that in a single-
section RC
filter.
The damping factor value corresponds to the
circuit time constant.
Usually a damping factor o
10 is recommended in applications.
Low Flow Cut off Value
Low Flow Cut off is used to make the system display
as "0" value at lower and smaller flows to avoid any
invalid totalizing. For example, if the cutoff value is
set as 0.03, system will take all the measured flow
values below ±0.03
as "0". Usually 0.03 is
recommended in most applications.
Menu
3
7
^
^
Menu
3
8
Enter
Menu 4 0
Menu 4
1
Attention
This operation will delete
the entire
consider carefully before taking this operation.
D116
Series Ultrasonic Flowmeter
Totalizer reset; all parameters are reset. Press
;
or "NO".
is selected, the following options are
to delete all the already set
default, select
flow meter
will reset
is a separate totalizer. Press
to stop it. It is used for flow
999 seconds.
0
the maximum
The damping function will stabilize the flow display.
section RC
The damping factor value corresponds to the
Usually a damping factor o
f 3 to
Low Flow Cut off is used to make the system display
as "0" value at lower and smaller flows to avoid any
invalid totalizing. For example, if the cutoff value is
set as 0.03, system will take all the measured flow
as "0". Usually 0.03 is
Enter
Totalizer Reset? [37
Selection
Enter
Manual Totalizer [38
Press ENT When Ready
Damping [40
10
sec
Low Flow Cutoff Val.
0.01
m/s
the entire
user’
s data and reset as the factory default. Please
consider carefully before taking this operation.
Series Ultrasonic Flowmeter
Page 28 of 53
Totalizer Reset? [37
Manual Totalizer [38
Press ENT When Ready
Damping [40
sec
Low Flow Cutoff Val.
m/s
s data and reset as the factory default. Please

PFlow Industries D116 Specifications

General

Brand	PFlow Industries
Model	D116
Category	Measuring Instruments
Language	English