PFlow Industries D116 User Manual

Revision: 3.0.3
Set Static State Zero
When fluid is in the static state, the displayed value is
zcalled "Zero Point". When "Zero Point
’ is not at zero
in the Flowmeter, the
difference is going to be added
into the actual flow values and measurement
Differences will occur in the Flowmeter.
Setting
zero must be carried out after the transducers
are installed and the flow inside the pipe is in the
absolute static state. Thus, the "Zero Point"
resulting
Reset Zero
Select "YES"; reset "Zero Point"
which was set by the
user.
Manual Zero Point
This method is
not commonly used. It is only suitable
for experienced operators to set zero under conditions
when it is not preferable to use other methods. Enter
the value manually to add to the measured value to
obtain the actual value. For example:
Actual measured value＝250 m3/H
Actual measured value＝10 m3/H
Flowmeter Display＝240 m3/H
Normally, set the value as "0".
Scale Factor
The scale factor named as instrument
K factor
to modify the measurement results.
The user can enter
a numerical value according to the actual
calibration
results.
Network IDN
Input system identifying code, these numbers can
be selected from 1~247 except
that 13 (0DH EN
TER), 10 (0AH Newline), 42 (2AH﹡
) and 38 (2
6H&) are reserved.
System IDN is used to identify the flowmeter to
a network.
Menu 4 2
Menu 4
3
Menu 4 4
Menu 4 5
Menu 4 6
D116
Series Ultrasonic Flowmeter
When fluid is in the static state, the displayed value is
’ is not at zero
difference is going to be added
into the actual flow values and measurement
.
zero must be carried out after the transducers
are installed and the flow inside the pipe is in the
resulting
which was set by the
not commonly used. It is only suitable
for experienced operators to set zero under conditions
when it is not preferable to use other methods. Enter
the value manually to add to the measured value to
K factor
is used
The user can enter
calibration
Input system identifying code, these numbers can
that 13 (0DH EN
) and 38 (2
System IDN is used to identify the flowmeter to
Set Zero [42
Press ENT to go
Reset Zero [43
NO
Manual Zero Point [44
0
m3/h
Scale Factor [45
1
Network IDN [46
88
Series Ultrasonic Flowmeter
Page 29 of 53
Set Zero [42
Press ENT to go
Reset Zero [43
Manual Zero Point [44
m3/h
Scale Factor [45
Network IDN [46

PFlow Industries D116 Specifications

General

Brand	PFlow Industries
Model	D116
Category	Measuring Instruments
Language	English