77
Selected resolution is not displayed properly
• Use OSD Display Mode to enter Information menu and confirm that the appropriate resolution has been selected.
If not, select corresponding option.
No Sound
• Check if mute function is activated.
• Check if volume is set at minimum.
Remote Control doesn’t work
• Check the Remote Control batteries status.
• Check if batteries are inserted correctly.
• Check if the Remote Control is pointing at the monitor remote sensor when operating.
“SCHEDULE”/“SLEEP TIMER” function is not working properly
• If “SCHEDULE” and “SLEEP TIMER” schedules are programmed at the same time, then the earliest / highest
numbered schedule has priority.
• “SLEEP TIMER” will be reset by the following reasons:
¾ If the “SLEEP TIMER” function is enable •
¾ If the power supply of LCD monitor is interrupted unexpectedly.
Stripe Noise
• Light vertical or horizontal stripes may appear depending on the specific display pattern. This is no product fault
or degradation.
“NO SIGNAL” is displayed on the screen
• Image may not be displayed right after HDCP device is connected.
To Next Page