Philips BDL5545E/00 - Installing and Removing the Stand; How to Install the Stand; How to Remove the Stand

User Manual BDL5545E
11
1.5. INSTALLING AND REMOVING THE STAND
1.5.1 How to install the stand
1. Turn off the display.
2. After inserting the stand in the guide block, tighten the screws on both sides of the monitor.
NOTE:
The long end of the stand should face the front while installing.
1.5.2 How to remove the stand
1. Spread a protective sheet on a flat surface.
2. Place the display face-down on a protective sheet.
3. Remove screws using a screwdriver and place them in a safe place for reuse.
Screw
Stands
"Longer end
faces the front"
Screw
Screw
Screw