Cleaning and Disinfecting the Monitor, Rack and Modules
Care and Cleaning
7-2 Efficia CM Series Rack and Modules Instructions for Use
Cleaning and Disinfecting the Monitor, Rack and Modules
To clean and disinfect the Efficia Monitor, Rack and Modules:
Reprocessing
Follow the above mentioned instructions for care and cleaning of your rack and modules.
For information on cleaning and reprocessing any accessories, see the Instructions for
Use that ships with the accessory.
Approved Cleaning Agents
The following cleaners have been tested and are approved for cleaning the Efficia rack
and measurement modules.
Caution Only use the approved cleaners. The use of unapproved cleaners will cause damage to
the rack and modules and void the warranty.
• Dismozon Plus
• Descogen Liquid RFU
• Descospet Pur
• Biguacid Liquid (Also known as Big Spray “new”)
Step
1
Dampen a soft cloth with any of the following solutions:
• Isopropyl alcohol (70% solution in water)
• Mild soap and water
• Sodium hypochlorite (chlorine bleach, 10% solution in
water)
• Quaternary ammonium chloride compounds (<1%)
• Hydrogen peroxide (<5%) with phosphoric acid (<5%)
• Peracetic acid (<1%) with Hydrogen peroxide (<1%)
• Sodium dichloroisocyanurate solid (48% before dilution)
• Ethylene glycol monobutyl ether (1% – 5%) with
isopropanol (17%)
• n-Alkyl dimethyl benzyl ammonium chloride (8.1%) before
dilution with didecyl dimethyl ammonium chloride (8.7%)
before dilution
• Diethylene glycol butyl ether (5 – 10% by weight)
• Sodium dodecylbenzenesulfonate solid (20% before
dilutions)
2
Wring any excess moisture from the cloth and wipe the
monitor at room temperature.
To Next Page
Loading...
