5756B
The following overview lists the sections of this
Quick Start Guide, which informs you about how
to start up the controller board and the entire
INTERBUS system.
Page 17
Page 24
Page 42
Page 57
Preparations
– Unpacking the controller board
– Description of the connecting and operating
elements
Installing the Controller Board
– Controller board installation in the PLC
– Inserting the parameterization memory
– INTERBUS system connection
Startup for Testing the INTERBUS System
– Startup of the entire system during the
installation phase to test the connected
INTERBUS devices
Appendix
– Replacing the controller board
– Replacing the parameterization memory
– Upgrading the firmware
– Connecting cable
Example of an INTERBUS and PLC Configuration
Startup With IBS CMD SWT G4
Configuration Software
– Startup of the controller board and the
connected INTERBUS system with
IBS CMD SWT G4 software. During startup
with IBS CMD SWT G4, all system options
are available
INTERBUS System Operation From the PLC
– Description of the INTERBUS standard and
diagnostic registers and its position in the
PLC
Page 27
Page 18
Page 4
Page 10
Automatic Diagnostic Functions
– Description of the diagnostic driver block
Page 52
INTERBUS Operating Modes
– Description of the timing interaction between the
INTERBUS and the PLC
Page 19Integration of the Controller Board in
STEP 7
– Integrating the controller board into the PLC
To Next Page
Loading...
Need help?
General
