Phytec phyFLEX-i.MX 6 - SPI Interface Details

phyFLEX
®
-i.MX 6
 Check the network settings with following command:
ifupeth0
devinfoeth0
The target should return these lines:
..ipaddr=192.168.3.11..... e
..netmask=255.255.255.0. ic
..gateway=255.255.255.0. .
..serverip=192.168.3.10...ev
If you need to change something, type:

edit/env/network/eth0
edit the settings, save them by leaving the editor with Strg-D, then typesaveenv and
reboot the board.
 Now we flash the root filesystem. T ype:
ubiformat/dev/nand0.root
ubiattach/dev/nand0.root
ubimkvol/dev/ubi0root0
cp/mnt/tftp/phytec‐qt5demo‐image‐phyflex‐imx6‐2.ubifs/dev/ubi0.root
 Enter boot to boot the phyFLEX-i.MX6 with the new kernel and root file system.
 After the target has successfully finished booting, type
root to log in.
60
 PHYTEC Messtechnik GmbH 2015 L-781e_7