PIAGGIO Beverly 400 E5 - Oil Pressure Check and Crankshaft Seals

Oil pressure check
- Remove the electrical minimum oil pressure
switch connection and remove the switch.
- Check that the oil pressure reading is between
0.5 and 1.2 bar with the engine idling at 1650 rpm
and the oil at the required temperature (wait for at
least one electric ventilation).
- Check that the oil pressure is between 3.2 and
4.2 bar with the engine running at 6000 rpm and
the oil at the required temperature.
- Remove the appropriate tools once the meas-
urement is complete, refit the oil pressure switch
and washer, tightening it to the specified torque
and fit the flywheel cover.
- If the oil pressure is not within the specified limits,
in the following order, check: the oil filter, the oil
by-pass valve, the oil pump and the crankshaft
seals.
N.B.
THE CHECK MUST BE CARRIED OUT WITH OIL AT THE
CORRECT LEVEL AND WITH AN OIL FILTER IN PROPER
CONDITION.
Characteristic
Oil pressure
Operating pressure
- At 1650 rpm: 0.5 - 1.2 bar
- At 6000 rpm: 3.2 - 4.2 bar
Locking torques (N*m)
Minimum oil pressure sensor 12 ÷ 14
Crankshaft oil seals
Engine Beverly 400 E5
ENG - 144