Removing the cylinder head
- Undo the two external screws.
- Gradually loosen the four columns in crossed se-
quence, recovering the washers.
- Remove the cylinder head.
N.B.
IF NEEDED, THE HEAD MAY BE REMOVED WITH THE
CAMSHAFT, PINS AND ROCKING LEVERS WITHOUT RE-
MOVING THE DRIVING PULLEY UNIT. REMEMBER TO
HOLD THE TIMING CHAIN WITH A PIECE OF METAL CA-
BLE AND TO ADJUST THE CHAIN TIGHTENER UPON RE-
FITTING.
- Remove the gasket.
Engine Beverly 400 E5
ENG - 126
To Next Page
Loading...
