GENERAL SAFETY WARNINGS:
1. Always wear protective goggles and suitable clothing.
2. Always use a safety support for operating under the vehicle.
3. Make sure the ignition switch is always OFF. unless otherwise specified in the procedure.
4. Pull the hand brake (if available) before starting work on the vehicle.
5. Operate the engine only in well ventilated places to avoid the risks associated with carbon mon-
oxide.
6. Keep away from moving parts during engine operation. especially from the fans and belts.
7. To avoid serious burns. avoid contact with hot metal parts such as the radiator. exhaust manifold.
exhaust pipe. catalytic converter and muffler.
8. Do not smoke during maintenance operations.
9. To avoid possible injury. do not wear rings. watches. jewellery or loose clothing before beginning
work on the vehicle.
10.Keep hands and other objects away from the radiator electric fan blades (if available)!
11.The electric cooling fan (if available) is mounted on the radiator and can start up at any time due
to an increase in coolant temperature. It is important to verify that the electric cooling fan motor
has been disconnected from the cable harness before starting work.
The units of measurement used in this manual are indicated as SI UNITS (International System
of Units). Example:24.5 to 34.3 Nm
General mandatory requirements Beverly 400 E5
NORM - 8
To Next Page
Loading...
