General information
This section contains general information about using the manual and the vehicle. as well as important
notes about safety.
WARNINGS AND IMPORTANT NOTES
Each symbol has a precise meaning. as shown below.
•
WARNING: - This symbol indicates the risk to the health of the operator or others in the
vicinity if the procedures are not carried out properly.
•
IMPORTANT!:- This symbol indicates that the component being worked on may be dam-
aged if the described procedures are not carried out properly.
•
N.B.:- This section provides additional instructions on the procedure in progress so that the
operation may be performed effectively.
WARNINGS REACH REGULATION:
In order to preserve the health and safety of the PROFESSIONAL CUSTOMER, as required by:
•
EC Regulation 1907/2006 (REACH);
•
EC Directive 2000/53/EC (END of LIFE VEHICLES);
•
SCIP Database Directive (Article 9, paragraph 1 letter i) of the Waste Framework Directive,
amended by Directive 2018/851
All technical personnel working engaged in scheduled and unscheduled maintenance activities are
required to wear the following personal protective equipment at all times:
1. chemical resistant gloves, where a specific type is not indicated, or, where required, specific
gloves for the substance handled;
2. face mask or, where specifically indicated, chemical filter mask;
3. protective eyewear.
The above is valid in the alternative to what is required by other regulations and by the laws in force in
specific countries. As regarding the use of other PPE, regulated by safety at work, the regulations in
force apply.
Beverly 400 E5 General mandatory requirements
NORM - 7
To Next Page
Loading...
