Look on the visible part of the coolant reservoir and
check that the fluid level is always the MIN and
MAX level marks.
Top up with fluid if the level is near the minimum
mark. If the level of the fluid is not correct, top it up.
This should be done when the engine is cold. If the
coolant needs to be topped up frequently or the
coolant reservoir is completely dry, check the cool-
ing system to determine the cause of the problem.
WARNING
TO AVOID THE RISK OF SCALDING, DO NOT UNSCREW
THE EXPANSION TANK COVER WHILE THE ENGINE IS
STILL HOT.
WARNING
YOU MUST MAKE SURE THE FLUID NEVER EXCEEDS
THE MAXIMUM LEVEL INDICATED SO AS TO AVOID IT
OVERFLOWING AND CAUSING DAMAGE WHILE THE
SCOOTER IS MOVING.
TO ENSURE CORRECT ENGINE OPERATION, KEEP THE
RADIATOR GRILLE CLEAN.
Level check
The front and rear brake fluid reservoirs are both
positioned on the handlebar. Proceed as follows:
- Rest the vehicle onto the centre stand, with the
handlebar centred.
- Check the fluid level through the sight glass
«A».
A certain lowering of the level is caused by wear
on the pads.
Beverly 400 E5 Maintenance
MAIN - 57
To Next Page
Loading...
