Pima FORCE Programming Guide

20
PIMA Electronic Systems
Parameter
Description
Arm/Disarm-
Other
Set codes for Arming and Disarming events, in any way other than by users.
Faults
Set event and restore codes for the following events:
1) Power: AC Fault, Low Battery, Power Loss, Detector’s Voltage Failure,
Fuse, Peripheral’s Power Fault .
2) Communication: Communication Fault, Telephone Line Fault, Cellular
Fault, Network Fault .
3) Sirens: External Siren Fault, Internal Siren Fault .
Alarms and
Others
Set event and restore codes for the following events:
1) Panic and Fire alarms, Technician On-site , Invalid Code, Test.
2) Tampers: Tamper 1-2 and Peripherals ’ Alarm and Restore codes.
6.1.3 Custom Zones Reports
System Configuration  CMS & Communications  Monitoring Stations  Custom Zones Reports
Set the codes (ContactID, SIA alarm and restore) for the custom zones. Custom zones are
based on modified zone types, but allow reporting with unique ContactID and SIA codes.
Below is a list of more frequently used events, which can be used with the custom zones.
Event
ContactID
SIA
Event
ContactID
SIA
Gas detected
151
GT
Low temp
159
ZA
Refrigeration
152
ZA
High Humidity
168
-
Loss of heat
153
ZA
Low Humidity
169
-
Water Leakage
154
WA
Low water pressure
201
WT
Low bottled gas level
157
GA
Low water level
204
WT
High temp
158
KA
6.2 PIMA Cloud
System Configuration  CMS & Communications  PIMA Cloud
Parameter
Description
Network (Ethernet)
Cellular Data
1. Select the communication path to the cloud.
2. The cloud’s URL (force.pimalink.com) and IP address (13000)
3. Set the Port to zero for the other path.
Main Path
Select if the cloud will be the main communication path. When cleared,
this path will back up the main path.
• Do not change the default URL or IP. Consult PIMA
when required.
• Do not select more than one main path!

Pima FORCE Specifications

General

Brand	Pima
Model	FORCE
Category	Security System
Language	English