16
En
Preparation
06
Preparation
Installing the Plasma Display
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
• For details on installation, refer to the instruction manual
supplied with the stand.
Operating Environment
Operating environment temperature and humidity:
+0 ˚C to +40 ˚C; less than 85 % RH (cooling vents not
blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or strong
artificial light)
The lower left section of the display unit shown in the
illustration above is the location of the MAIN POWER switch
and certain parts required for display, and the contour involves
a raised projection.
As a result, when transporting and installing the unit, take
adequate precautions not to subject this area to impact or
unreasonable force, since damage to the parts may result.
Over 50 cm
Over
10 cm
POWER ON STANDBY
To Next Page
Loading...
Need help?
General
